Dynojet 250: Torque Module User Manual
Page 9
Advertising
TO R Q U E M O D U L E I N S T A L L A T I O N
Torque Module Installation
Version 4
Torque Module Installation and User Guide for Model 250 Dynamometers
1-5
6
Secure the Torque Module to the dyno electronics with the plastic tie straps (one
on each side).
7
Attach the 9-pin connector on the load cell cable to the front of the Torque
Module and tighten down the screws.
8
Attach the power cord to the dyno electronics and turn the power switch on.
The green LED light on the Torque Module should now be on.
Figure 1-3: Attach Torque Module and Load Cell Cable
load cell cable and port
green LED light
tie strap
torque module
Advertising