EFCO 406 (T) Series - Manual (Page 19)

A - DOOR FRAME ASSEMBLY
K996 SIM.
See #Y014 for International C.O.C. Installation Instructions.
See #Y013 for Dorma C.O.C. Installation Instructions.
If the jambs are not factory prepped, please
HEAD SHEAR
K978 PKG.
see page 18 for transom jamb glazing pocket cut out.
glazing stop tracks on the top of the transom bar.
Be sure the snap-in glazing pocket has been notched to clear the
Attach the transom bar to the jamb with the #K978 shear block
SECTION IV ASSEMBLY & INSTALLATION
or the K996 and the 'F' clip or angle bracket (#FT16) for a C.O.C.
NOTE: If an entrance frame is required, it must be installed first.
THIS ASSEMBLY IS
Factory prep shown.
SEE PAGE 23
AT A SINGLE DOOR.
OPPOSITE A C.O.C.
Please see page 16 for this end prep.
8402 DOOR JAMB
BLOCK PREP
Fig. # 15
Apply sealant to the
end of the transom bar
before attaching it to
TRANSOM BAR
the shear block.
8400
PAGE 17
DPS 12/2002 406 STOREFRONT