EFCO 406 (T) Series - Manual (Page 37)

SECTION V GLAZING
B - GLASS INSTALLATION
TRANSOM BAR GLAZING STOP SEAL.
STEP 1) GASKET INSTALLATION FOR OUTSIDE GLAZE
IF SCREW APPLIED GLAZING STOPS ARE USED VERTICALLY INSTEAD OF
THE SNAP-IN GLAZING POCKET, THE SEALING SCENARIO WILL BE THE
SAME. BE SURE TO SET THE GLAZING BASE IN A BEAD OF SEALANT
BEFORE ATTACHING IT TO THE DOOR JAMB.
Exterior glass stop shown in place,
remove to set the glass unit.
this will allow weepage.
Do not seal the exterior glass stop,
Seal the interior glass stop leg to
the transom bar and seal the end
joint to the jamb and transom bar
w/ #9358 GLAZING
ADAPTOR
NOTE:
completely.
#8402 DOOR JAMB
TYPICAL ALL 4 CORNERS OF D.L.O..
APPLY SEALANT IN GASKET RACE
1" FROM INTERSECTION
GLAZING POCKET
CUT LENGTH = D.LO. - 13/32".
# 9123 GLASS STOP
#8400
Fig. # 41
(48" MAX.)
#8403 SNAP-IN
(CONT.)
406 STOREFRONT RAM 4/2004
PAGE 35