EFCO 406 (T) Series - Manual (Page 26)

#8400
perimeter filler if structural loads require a greater shear strength at the anchor locations.
NOTE: These are general anchor locations. It may be necessary to use 9358 as the
All projects should be reviewed by a structural engineer for exact anchoring requirements
15" on center, typical spacing.
located 6" from the ends and
the jambs and tied into mullion sealant
16" on center, maximum spacing.
Continuous bead of sealant at
screws located 6" from the ends and
Anchor through the transom bar at
the back of the threshold and sides of
the door stop centerline with flat head
Fig. # 25
16" on center, maximum spacing.
Anchor through the S.S. jamb at
the door stop centerline with flat head
screws located 6" from the ends and
EXTERIOR
Attach through the threshold
at the condition.
with flat head screws
Fig. # 23
INTERIOR
Fig. # 24
SECTION IV ASSEMBLY & INSTALLATION
B - DOOR FRAME INSTALLATION
#9359
maximum spacing.
6" from the ends and 16" on center,
glazing pocket with flat head screws located
Anchor through the transom head/frame head
LB78/FV16
glazing pockets or distorting the door jamb.
anchors. This is to prevent collapsing the
locate them at the frame and door frame
backer (LB78) or use 3" pieces (FV16) and
recommends using full lengths of caulk
At the open back head and jamb, EFCO
LB78/FV1
6
Fig. # 22
#8402 SHO
W
N
(CONT.)
406 STOREFRONT CSJ 11/2007
PAGE 24
9359 frame jamb & 9357 frame sill require
LB78/FV16 similar.