EFCO 406 (T) Series - Manual (Page 25)

K-153/K-154 Threshold Clip & Screws
@ Concealed Rod Panic
K-124/K-125 Threshold Clip & Screws
The door jamb runs to the
@ Offset Pivots & Butt Hinges
than any other vertical
floor and is cut longer
member.
NOTE:
SIDE LITE SILL
& FLASHING
#9357/1G83
(9950)
THRESHOLD
#8402
Fig. # 21
of sealant to tie into
underside of sill.
Continuous bead
AND CONTINUING UNDER THE THRESHOLD TO THE OPPOSITE JAMB
FROM THE SILL FLASHING/CONDITION THROUGH THE DOOR JAMB
CONTINUOUS BEAD OF SEALANT AT THE INTERIOR, CONNECTED
BE APPLIED UNDER THE THRESHOLD. THE CONCEPT IS TO HAVE A
SEALANT OR CONDITION SEALANT INTO THE BEAD OS SEALANT TO
THE JAMB TO SET THE MEMBER INTO. THEN MARRY THE SIDE LITE
APPLY A BEAD OF SEALANT AROUND THE INTERIOR PORTION OF
B - DOOR FRAME INSTALLATION
SET THE ASSEMBLED DOOR FRAME IN THE OPENING,
ANCHOR THE DOOR FRAME AS INDICATED BELOW AND IN
SECTION IV ASSEMBLY & INSTALLATION
CORRECTLY LOCATE THE ENTRANCE FRAME IN THE OPENING.
NOTE: If an entrance frame is required, it must be installed first.
STEP 2)
STEP 4)
STEP 3)
STEP 1)
FIG. #22 THROUGH FIG. #25 ON PAGE 24.
AND SO ON.
PLUMB AND LEVEL.
406 STOREFRONT DPS 12/2002
PAGE 23