Archived 4/2/10 – ETS-Lindgren HI-4457 Isotropic Magnetic Field Probe (Archived) User Manual
Page 32
Advertising
HI
n
4457 Manual
Page — 27
Commands
Command
Description
B
Read battery voltage.
Cx
Set baud rate.
x = 1 sets rate to 2400 baud
x = 2 sets rate to 9600 baud
New baud rate does not take effect until
the next power-up.
Dx
Read probe data.
x = 1 enables short form output
x = 2 enables long form output
Lx
Load table data. x = ASCII hex data
Rx
Set range. x = 1, 2, 3, 4 or N (next
range)
Sx
Sleep timer. x = number of seconds to
wait for a command before putting the
probe into the sleep mode.
Tx
Read Temperature. x = C or F
Ux
Set unit type. x = 1, 2, 3, or N (next unit)
1 = A/m
2 = mW/cm²
3 = [ A/m]²
Vtx
Verify table data. t = table (same table as
for the Lx command, above). x = number
of bytes to send in one string.
Z
Zero.
Archived 4/2/10
Advertising