Kontron KTQ67-FLEX - Manual (Page 20)

KTQ67 Users Guide
KTD-N0829-G Page 20
2.4 System Memory support
The KTQ67/FLEX and /ATXE have four DDR3 UDIMM sockets. The sockets support the following
memory features:
• 4x DDR3 1.5V UDIMM 240-pin
• Dual-channel with 2 UDIMM per channel
• Single/dual rank unbuffered 1066/1333MT/s (PC3-8500/PC3-10600)
From 256MB and up to 4x 8GB.
Note: Less than 4GB displayed in System Properties using 32bit OS
(Shared Video Memory/PCI resources is subtracted)
• SPD timings supported
• ECC not supported
The installed DDR3 DIMM should support the Serial Presence Detect (SPD) data structure. This allows
the BIOS to read and configure the memory controller for optimal performance. If non-SPD memory is
used, the BIOS will attempt to configure the memory settings, but performance and reliability may be
impacted.
Memory Operating Frequencies
Regardless of the DIMM type used, the memory frequency will either be equal to or less than the
processor system bus frequency. For example, if DDR3 1600 memory is used with a 1333 MHz system
bus frequency processor, the memory clock will operate at 666 MHz. The table below lists the resulting
operating memory frequencies based on the combination of DIMMs and processors.
DIMM Type Module
name
Memory
Data
transfers
[Mill/s]
Processor
system bus
frequency
[MHz]
Resulting
memory clock
frequency
[MHz]
Peak transfer
rate
[MB/s]
DDR3 1066 PC3-8500 1066 1066 / 1333 533 8533
DDR3 1333 PC3-10600 1333 1333 666 10666
DDR3 1600 PC3-12800 1600 1333 666 10666
Notes: Kontron offers the following memory modules:
1054-2766 1GB DDR3 1066
1031-9872 1GB DDR3 1333
1054-3706 1GB DDR3 1600
1054-2768 2GB DDR3 1066
1054-3702 2GB DDR3 1333
1054-3707 2GB DDR3 1600
1054-3700 4GB DDR3 1066
1054-3703 4GB DDR3 1333
1054-3708 4GB DDR3 1600
1054-3704 8GB DDR3 1333
1052-5601 8GB DDR3 1600
DDR3 (SLOT B1)
DDR3 (SLOT B0)
DDR3 (SLOT A1)
DDR3 (SLOT A0)
(Example Flex version)
System Specification
It has not been verified that the combination of CPU
supporting Bus Speed 1600 MHz and DDR3 1600 actually
runs at 1600 MHz.
In order to support Intel ® AMT (Management Engine) SLOT
A0 must always be populated. In case of using more than a
single DIMM it is recommended to populate A0 + B0 first.