Kontron KTQ67-FLEX - Manual (Page 30)

KTQ67 Users Guide
KTD-N0829-G Page 30
5 IO-Area Connectors
5.1 Display connectors (IO Area)
The KTQ67 family provides one on-board Analogue VGA port, two on-board DP’s (DisplayPort) and
optionally one on-board LVDS panel interface. Two graphic pipes are supported; meaning that up to two
independent displays can be implemented using any two of the above mentioned graphic ports.
.
5.1.1 Analogue VGA (VGA)
Note
Pull
U/D
Ioh/Iol Type Signal PIN Signal Type Ioh/Iol
Pull
U/D
Note
6 GND PWR - -
/75R - A0 RED 1 11 NC - - -
7 GND PWR - -
/75R - A0 GREEN 2 12 DDCDAT IO TBD 2K2
8 GND PWR - -
/75R - A0 BLUE 3 13 HSYNC O TBD
9 5V PWR - - 1
- - - NC 4 14 VSYNC O TBD
10 GND PWR - -
- - PWR GND 5 15 DDCCLK IO TBD 2K2
Note 1: The +5V supply is fused by a 1.1A resettable fuse
Signal Description - VGA Connector:
Pin Signal Description
1 RED Analogue output carrying the red colour values. (75 Ohm cable impedance).
2 GREEN Analogue output carrying the green colour values. (75 Ohm cable impedance).
3
BLUE Analogue output carrying the blue colour values. (75 Ohm cable impedance).
4 NC No Connection
5-8 GND
9 5V This 5V supply is fused by a 1.1A resettable fuse.
10 GND
11 NC No Connection
12 DDCDAT Display Data Channel Data. Used as data signal to/from monitors with DDC interface.
13 HSYNC CRT horizontal synchronization output.
14 VSYNC CRT vertical synchronization output.
15 DDCCLK Display Data Channel Clock. Used as clock signal to/from monitors with DDC interface.
IO-Area Connectors