Table 6-6: sconf command, Table 6-6, Sconf – Kontron COMe-cP2020 User Manual
Page 85
www.kontron.com
COMe-P2020 User Guide
85
Table 6-6:
sconf Command
sconf
Provides functions for configuration of external interfaces
SYNTAX:
sconf info|select <num>|set [<par> <val>]|clear|save|undo|raw
<byte0|byte1|..|byte16>
sconf
command
info
option:
displays available configurations
select
option:
selects base configuration <num>
<num>
parameter: decimal
<0, 1, ... 8>
number of base configuration
set
option:
indicate or configure parameter for new base configuration
<par>
parameter: ascii string
<x...x>
parameter for new base configuration
<val>
parameter: ascii string
<x...x>
value assigned to <par>
clear
option:
clear user config settings in glue logic and reboot
save
option:
saves the current settings
undo
option:
undo current changes not yet saved
DESCRIPTION: This command is used to configure external interfaces available on the COMe-cP2020’s connectors.
The “sconf info” command shows the possible configurations as well as the currently selected
configuration.
The active configuration is indicated by ‘**’ characters in the “sconf info” output messages.
To configure external interfaces, select a base configuration via the “sconf select” command. Then, the
parameters can be defined more exactly by the “sconf set <par>” subcommands.
To apply the configuration, invoke the “sconf save” command. After having updated the configuration in
the glue logic, a module powercycle is performed automatically (a hardware reset is not sufficient to
activate the new configuration).