Table 6-6 – Kontron COMe-cP2020 User Manual
Page 87
www.kontron.com
COMe-P2020 User Guide
87
2. Select new base configuration
=> sconf select 7
Default configuration active
=========+-===============+-===============+-===============+-
===============
Base | Serdes #0 | Serdes #1 | Serdes #2 | Serdes #3
Config | | | |
=========+-===============+-===============+-===============+-
===============
|
< 0> | OFF OFF OFF OFF
|
**< 1>**| PCIEx4 @2.5 RC
|
< 2> | PCIEx1 @2.5 RC PCIEx1 @2.5 RC PCIEx2 @2.5 RC
|
< 3> | PCIEx2 @2.5 RC PCIEx2 @2.5 RC
|
< 4> | PCIEx1 @2.5 RC PCIEx1 @2.5 RC SGMII SGMII
|
< 5> | PCIEx2 @2.5 RC SGMII SGMII
|
< 6> | PCIEx1 @2.5 RC SRIOx1 @2.5 H SGMII SGMII
|
--[ 7]--| SRIOx1 @2.5 H SRIOx1 @2.5 H SGMII SGMII
|
< 8> | SRIOx4 @3.125H
eTSEC2 configured in SGMII mode
eTSEC3 configured in SGMII mode
SRIO host mode, device ID is 0
Boot ROM location is spi
=>
3. confine new base configuration
=> sconf set etsec2 rgmii
Default configuration active
=> sconf set etsec3 rgmii
Default configuration active
4. check changes
=> sconf info
Default configuration active
...
eTSEC2 configured in RGMII mode
eTSEC3 configured in RGMII mode
SRIO host mode, device ID is 0
Boot ROM location is spi
=>
5. Save new configuration. Board is power-cycled automatically
=> sconf save
Table 6-6:
sconf Command (Continued)