Mercedes-Benz S-Class 2009 - Manual (Page 113)

COMAND navigation system (entering a destination)
111
distance taking distance and driving time
into account.
X Select Navi £ Navi £ Mode.
The mode list appears. A square ÿ
indicates the current setting.
X Select route type: Fast Route or Short
Route.
X Exit menu: Slide o m p or press back
button L in the center console
( Y page 90).
i If you change the route type setting during
active route guidance, COMAND calculates
a new route. If you change the setting when
route guidance is inactive, COMAND uses
the new setting for the next route guidance.
Setting route mode
i This function allows you to set the
following options for route guidance:
R
Minimize Highways
R Minimize Toll Roads
R Minimize Tunnels
R
Minimize Ferries/Motorail
X Select Navi £ Navi £ Mode.
The mode list appears.
X Switching mode on or off: Select desired
modes.
Depending on the previous status, the
mode is switched on or off. A checkmark
indicates that the mode is switched on. It
is possible to switch on more than one
mode.
X Exiting menu: Slide o m p or press back
button L in the center console
( Y page 90).
COMAND will verify whether it can
incorporate the modes if you select them
with route guidance active.
If it can, COMAND calculates a new route
while incorporating the modes selected.
If it cannot, you will see and hear a
corresponding message.
X Select OK.
COMAND calculates a new route. Only
those modes which can be incorporated
are used.
COMAND navigation system (entering
a destination)
Introduction
G Warning!
For safety reasons, only enter a new
destination when the vehicle is stationary.
i It is possible to enter a destination
regardless of whether route guidance is
active or inactive.
The following destination entry options are
available:
R Entering a destination by address
R Entering a destination from the destination
memory
R Entering a destination from the list of last
destinations
R Entering a destination from the map
R Entering a stopover
R Entering a POI
Control systems
Z