Mercedes-Benz S-Class 2009 - Manual (Page 148)

COMAND navigation system (during route guidance)
146
i COMAND uses the time set in COMAND
as the basis for calculating the estimated
arrival time. The clock must be set correctly
in COMAND (
Y page 96). The calculation of
the estimated arrival time does not
additionally take into account whether
Daylight Saving Time or standard time is
applicable at the destination. If the
destination is in a different time zone,
arrival time display
9 is in local time. This
is indicated by LT in the display.
The following data cannot be seen until the
route calculation has been completed:
R Distance to destination 2
R Estimated arrival time 9
R Estimated remaining travel time 8
If the destination is located within a
partially digitized area, the following data
may differ from the facts:
R Distance to destination 2
R Estimated arrival time 9
R Estimated remaining travel time 8
Displaying route information
X Select Route £ Route Info in map view
with the menu system displayed
(
Y page 107).
The route information appears.
1 Highlighted portion of route
2 Info for highlighted portion of route
3 Next portion of route
X Closing route info: Slide o m p or press
back button L in the center console
( Y page 90).
X Displaying next or previous route
section: Select Next or Previous.
X Increasing or reducing size of the map:
Select ; or : .
X Closing route browser: Select Back.
Detour function
i The detour function blocks a section of
the route ahead of you. You can set the
length of the blockage. If possible,
COMAND calculates a detour route.
i The detour function may direct you to off-
road routes. See Off-road and Off-map for
additional routes and cautions
(
Y page 142).
X Select Route £ Detour in map view with
the menu system displayed ( Y page 107).
The detour function display appears.
X Setting length of the blockage: Select
More or Less until the desired length is set.
Control systems