Rice Lake 120 Plus Digital Weight Indicator - Manual (Page 25)

Configuration 21
Address 00
number Specifies the node address of RS485. The value is in hex format. 00 represents that this
function is disabled.
If ADDRESS is enabled, EDP commands became <ADDRESS> + command, where
address is one byte, and auto off echo even if echo is on.
Note: User can connect via an external RS232 to RS485 converter.
Print BAUD
BITS
TERM
LANGUAGE Specifies port settings for baud rate, data bits, termination characters, and end- of-line
delay used by the printer port.
Baud 9600
1200
2400
4800 Baud Rate. Selects the transmission speed for the printer port.
Bits 8NONE
7ODD
7EVEN
7SPACE Selects number of data bits and parity of data transmitted from the printer port.
Termination CR/ LF
CR Selects the termination character for data sent from the printer port.
Language ENGLIS
GERMAN Ticket language. Selects the language for the printer tickets.
English/ German Gross/ Brutto
Net/ Netto Tare/ Tara
Height/ Groesse
Print Destination EDP
PRN Print destination. Selects the port for data transmission when the PRINT key is pressed
or the KPRINT EDP command is sent.
Stream OFF
EDP
PRN Selects the serial port used for continuous transmission. See " Continuous Output
(Stream) Format" on page 46 for more information about the 120 Plus
continuous data format.
Stream Delay 250MS
500MS
1SEC
2SEC
4SEC
8SEC
15SEC
OFF Specifies the delay in seconds (SEC) or milliseconds (MS) inserted between stream
frames.
Cinstr OFF
ON Selects to enable or disable the stream display for additional raw data and time.
Monbat OFF
ON Selects to enable or disable the stream display for additional battery data.
Protect DISABLE
ENABLE EDP port protection. Selects ENABLE to secure the EDP port from configuration
changes.
Parameter Options Description
Table 3-5. Serial Menu