0 test mode operations, Figure 4-1. test mode operation menu, Table 4-1. test mode option parameters – Rice Lake 120 Plus Digital Weight Indicator User Manual
Page 33: E section 4.0 for mor, For three seconds. the display will change from
Test Mode Operations
29
4.0
Test Mode Operations
Use this mode to test the parameters of the weight indicator.
This procedure should only be performed by a certified technician.
To enter test mode, press the “
setup switch
” for three seconds. The display will change from
CONFIG to A/DTST
.
Figure 4-1. Test Mode Operation Menu
Parameter
Description
A/D TEST
Displays A/D Test. Press the ENTER key to display the raw count value from A/D converter.
TEST LCD
Light on all LCD segments for test LCD.
I/O
Display digital input (Remote Switch) and output (Set Point) status.
BATTERY
VOLTAGE
Display battery voltage in V.
BATTER
CURRENT
Display battery charging current in A.
FILTER 3
Displays filtered raw count for digital filter 3.
DEFAULT
Default parameters. Press the ENTER key to reset configuration and calibration parameters to
factory default values.
NOTE: Not available in panel mode operation
TRANSMIT U
Transmits "U". Press the ENTER key to send the U character [ASCII: 85 decimal, 55 hex] to test
the serial line quality and integrity.
Table 4-1. Test Mode Option Parameters
Note
T
N
E
R
R
U
C
Y
R
E
T
T
A
B
E
G
A
T
L
O
V
Y
R
E
T
T
A
B
T
S
E
T
D
/
A
uuuuuu
READY
DEFAULT
TRANSMIT U
ECHO R
TEST LCD
IO
FEC600
FILTER3
0 0 0 0 0
OUT2
OUT1
RSW3
RSW2
RSW1