Rice Lake 120 Plus Digital Weight Indicator - Manual (Page 43)

Appendix 39
8.1.7 Print Format Commands
8.1.8 Set Points Commands
Command Description Values
WWPF Print format strings in visible ASCII characters See "Print Formats"
WPF Print format strings in ASCII hex code See "Print Formats"
Table 8-7. PFROMT Commands
Command Description Values
S1.KIND Kinds of Operation mode for set point 1 OFF, GROSS, NET, DISPLA, ABSNET
S1.CONTACT Contact status below the set point 1
value N.CLOSE, N.OPEN
S1.CONDITI Output enabled only after the weight
reading has stabilized NORMAL, STABLE
S1.WAVL Set weight thresholds for set point 1.
Output 1 active if load over this weight
(load >= wval) 0 - 999999
S1.HYSTER Set weight thresholds for set point 1.
Output 1 deactive if load under this
weight (load < wval
x hysteresis) 0%, 2%, 5%, and 10%
S1.TIMER Output is disabled after the time period
has expired None, 250ms, 500ms, 750ms, 1.5Sec, 3.0Sec, 4.0Sec, 5.0Sec
S1.DELAY Time delay before the output is enabled None, 250ms, 500ms, 750ms, 1.5Sec, 3.0Sec, 4.0Sec, 5.0Sec
S1.BUZZER Enable/Disable set point OFF, ON
S2.KIND Kinds of Operation mode for set point 2 OFF, GROSS, NET, DISPLA, ABSNET
S2.CONTACT Contact status below the set point 2
value N.CLOSE, N.OPEN
S2.CONDITI Output enabled only after the weight
reading has stabilized NORMAL, STABLE
S2.WAVL Set weight thresholds for set point 2.
Output 2 active if load over this weight
(load >= wval) 0 - 999999
S2.HYSTER Set weight thresholds for set point 2.
Output 2 deactive if load under this
weight. (load < wval x hysteresis) 0%, 2%, 5%, and 10%
S2.TIMER The output is disabled after the time
period has expired None, 250 ms, 500 ms, 750 ms, 1.5 sec, 3.0 sec, 4.0 sec, 5.0
sec
S2.DELAY Time delay before the output is enabled None, 250 ms, 500 ms, 750 ms, 1.5 sec, 3.0 sec, 4.0 sec, 5.0
sec
S2.BUZZER Enable/Disable set point OFF, ON
RSWDEF Specifies the function activated by
remote switch inputs 1, 2, and 3. OF.OF.OF, PR.TA.ZO, UN.TA.ZO
Table 8-8. Set Points Commands