Rice Lake 120 Plus Digital Weight Indicator - Manual (Page 30)

26 120Plus Digital Weight Indicator Technical Manual
The following table describes the various set points options (values in bold are default values).
Parameter Options Description
Set Point 1 OFF
KIND
CONTACT
CONDIT
WVAL
TIMER
DELAY
HYSTER
BUZZER Specifies settings for mode, contact type, stability, weight valve, timer, delay, and
hysteresis used by the set point 1.
Operation Mode OFF
GROSS
NET
DISPLA Specifies kinds of Operation mode, comparator source.
Contact Type N.CLOSE
N.OPEN Contact type. Contact status below the set point value, Comparator output to be normal
open or normal close.
Stability NORMAL
STABLE Output enabled only after the weight reading has been stabilized.
Weight Value 10 or 20
number Sets weight thresholds for set point.
Output active if load over this weight. (load >= wval)
Timer NONE
250MS
500MS
750MS
1.5SEC
3.0SEC
4.0SEC
5.0SEC Disables output after a specified time.
Delay NONE
250MS
500MS
750MS
1.5SEC
3.0SEC
4.0SEC
5.0SEC Time delay before the output is enabled.
Hysteresis 0%
2%
5%
10% Sets weight thresholds for set point.
Output deactive if load under this weight. (load<wval x hysteresis)
Buzzer OFF
ON Enable or disable beep from indicator when set point tripped
Set Point 2 OFF
KIND
CONTACT
CONDIT
WVAL
TIMER
DELAY
HYSTER
BUZZER Specifies settings for mode, contact type, stability, weight valve, timer, delay, and
hysteresis used by the set point 2.
Table 3-8. Setpoints Menu