Rice Lake 920i Installation Manual V1.05 User Manual
Page 33
Configuration
29
Figure 3-6. SCALES Menu, CALIBR Submenu
SCALES Menu, CALIBR Submenu
Parameter
Choices
Description
Level 4, CALIBR submenu
WZERO
—
Press ENTER to display and edit the zero calibration A/D count or millivolts value.
WVAL
—
Press ENTER to display and edit the test weight value.
WSPAN
—
Press ENTER to display and edit the span calibration A/D count or millivolts value.
WLIN
PT->1 —
PT->5
Press ENTER to display and edit test weight and calibration values for up to five linearization points.
Perform linear calibration only after WZERO and WSPAN have been set.
REZERO
—
Press ENTER to remove an offset value from the zero and span calibrations.
NOTE: Use this parameter only after WZERO and WSPAN have been set. See Section 4.2 on
page 40 for more information about using this parameter.
Table 3-4. SCALES Menu, CALIBR Submenu Parameters
WZERO
WVAL
WSPAN
WLIN
REZERO
PT->4
PT->5
PT->1
PT->2
PT->3
VISIBLE
GRADS
FORMAT
CALIBR
…
…