Rice Lake 920i Installation Manual V1.05 - Manual (Page 95)

Appendix 91
10.3 PS/2 Keyboard Interface
Serial port 2 on the 920i CPU board provides a
PS/2-type keyboard interface for use with a remote
keyboard. To use the keyboard interface, set the
INPUT parameter for Port 2 (under the SERIAL
menu) to
KEYBD .
Table 10-5 summarizes the 920i -speciÞc functions
provided by the keyboard interface; most other
alphanumeric and navigational keys provide functions
equivalent to those typical for PC operation.
NOTE: The keyboard interface is not hot-pluggable.
Disconnect power to the 920i before plugging the
keyboard cable into the Port 2 connector.
10.4 Serial Scale Interface
Serial ports 3 through 32 can be conÞgured for serial
scale input. The serial scale function allows other
scale indicators to send gross, net, or tare weight data
to the
920i . Once a serial port has been conÞgured to
accept scale data, the data format can be customized
to match the data stream sent by that indicator.
To conÞgure a serial scale, do the following:
1. Under the SERIAL menu, set the INPUT
parameter for the selected port to SCALE.
2. Return to the SCALES menu. Under
CONFIG, drop down and select the serial
port. If the serial scale is not shown, press the
Change Type softkey to select available serial
scales, then use the navigational keys to select
the serial scale. Press
Add to move the scale
to the righthand column, the press Done .
3. Under the SERIAL menu, return to the
selected port and set the format under the
SFMT parameter to match the format sent by
the serial scale.
The default serial scale format is:
<2><P><W7.><U><M><S><CR><LF>
where:
<2> STX character
<P> Polarity
<W7.> Seven bits of net data with decimal point
<M> Mode
<U> Units
<S> Status
<CR> Carriage return
<LF> Line feed
See Section 10.5 for information about stream
formatting and format identiÞers.
iRev provides several preset scale formats within its
Stream Formatting function. Figure 10-1 shows one of
the
iRev stream formatting displays.
Figure 10-1. iRev Stream Formatting Display
10.5 Custom Stream Formatting
Each port can be independently conÞgured to stream a
default frame format or can be customized to stream a
user-deÞned format. Custom formatting is very
similar to the standard print formatting described in
Section 6.0.
Table 10-6 on page 92 lists the format identiÞers used
to conÞgure a custom stream format. See Section 10.6
on page 94 for examples of custom stream formats.
Key Function
F1 ZERO key
F2 GROSS/NET key
F3 TARE key
F4 UNITS key
F5 PRINT key
F6 Softkey 1
F7 Softkey 2
F8 Softkey 3
F9 Softkey 4
F10 Softkey 5
F11 Not used
F12
Print Screen Same as PRINT key, in both normal and
setup modes
Table 10-5. PS/2 Keyboard Functions