Rice Lake 920i Installation Manual V1.05 - Manual (Page 82)

78 920i Installation Manual
9.1.5 Normal Mode Commands
The normal mode print commands (see Table 9-11) transmit data to the serial port on demand in either setup or
normal mode.
Command Description
DON.b#s Set digital output on (active) at bit b, slot n.
DOFF.b#s Set digital output off (inactive) at bit b, slot n.
Table 9-8. DIG I/O Serial Commands
Command Description Values
DIO.b#s Digital input function OFF, INPUT, OUTPUT, ZERO, NT/GRS, TARE, UNITS, PRINT,
ACCUM, SETPNT, TIMDATE, ESC, CLEAR, DSPTAR, IDKEY,
KEY0–KEY9, KEYDP, ENTER, KBDLOC, HOLD, BATRUN,
BATSTRT, BATPAUS, BATRESET, CLRCN, GROSS, NET, PRIM,
SEC, CLRTAR, CLRACC
Digital inputs are specified by bit number (b) and slot number (s)
Table 9-9. DIG IN Serial Commands
Command Description Values
ALG.ALIAS#s Analog output alias name
ALG.SOURCE#s Analog output source USER, SCALEn
ALG.MODE#s Mode GROSS, NET
ALG.OFFSET#s Zero offset 0%, 20%
ALG.ERRACT#s Error action FULLSC, HOLD, ZEROSC
ALG.MIN#s Minimum value tracked 0–9999999
ALG.MAX#s Maximum value tracked 0–9999999
ALG.ZERO#s Zero calibration 0–65535
ALG.SPAN#s Span calibration 0–65535
For commands ending with “#s”, s is the slot number.
Table 9-10. ALGOUT Serial Commands (Valid Only If Analog Output Card Is Installed)
Command Description Values
CONSNUM Set consecutive number 0–9 999 999
UID Set unit ID nnnnnnn
SD Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit
date using the year-month-day order specified for the
DATEFMT parameter, using only the last two digits of the year.
ST Set time hhmm (enter using 24-hour format)
SX#n Start serial port streaming OK or ??
The port streaming parameter (EDP.STREAM#p) for the
streaming port must be set to LFT or INDUST before using
these commands.
An EX command sent while in setup mode does not take
effect until the indicator is returned to normal mode.
EX#n Stop serial port streaming
Table 9-11. Normal Mode Serial Commands