Rice Lake 920i Installation Manual V1.05 - Manual (Page 81)

Serial Commands 77
SP.PSHPRINT#n Push print OFF, ON, WAITSS
SP.PSHTARE#n Push tare OFF, ON
SP.ALARM#n Alarm enable OFF, ON
SP.NAME#n Setpoint name number NONE, 1–60
SP.ACCESS#n Setpoint access OFF, ON, HIDE
SP.SLOT#n Digital output slot number
SP.DIGOUT#n Digital output number
SP.BRANCH#n Branch destination 0, 1-100
SP.RELNUM#n Relative setpoint numer 1–100
SP.START#n Starting setpoint 1–100
SP.END#n Ending setpoint 1–100
SP.DSLOT#n Digital input slot number
SP.MASK#n Digital input mask number
SP.NSAMPLE#n Number of samples number
SP.TIME#n Trip time hhmm
SP.DURATION#n Trip duration hhmmss
SP.VUNDER#n Underrange value number
SP.VOVER#n Overrange value number
BATCHNG Batching mode OFF, AUTO, MANUAL
For setpoint commands ending with “#n”, n is the setpoint number.
Command Description Values
GFMT.FMT
GFMT.PORT Gross demand print format string For .PORT commands, specify the port number as PORTxx (no
leading zero). For example: GFMT.PORT=PORT3.
See Section 6.0 on page 47 for information about demand print
format strings.
NFMT.FMT
NFMT.PORT Net demand print format string
ACC.FMT
ACC.PORT Accumulator print format string
SPFMT.FMT
SPFMT.PORT Setpoint print format string
TRWIN.FMT
TRWIN.PORT Truck weigh-in print format string
TRWOUT.FMT
TRWOUT.PORT Truck weigh-out print format string
TR.FMT
TR.PORT Truck register print format string
HDRFMT1
HDRFMT2 Ticket header format strings
AUXFMT.FMT
AUXFMT.PORT Auxiliary ticket format
WDGT#n Display widget widget_number
See Section 9.2 on page 82 for widget programming information.
WDGT.CLR Clear widgets —
Table 9-7. PFORMT Serial Commands
Command Description Values
Table 9-6. SETPNTS Serial Commands (Continued)