Rice Lake 920i Installation Manual V1.05 - Manual (Page 79)

Serial Commands 75
Command Description Values
EDP.BAUD#p Port baud rate 300, 600, 1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600,
115200
EDP.BITS#p Port data bits/parity 8NONE, 7EVEN, 7ODD
EDP.TERMIN#p Port termination character CR/LF, CR
EDP.EOLDLY#p Port end-of-line delay 0–255 (0.1-second intervals)
EDP.HANDSHK#p Port handshaking OFF, ON, HRDWAR
EDP.ADDRESS#p Port RS-485 address 0, 1–255
EDP.BUS#p Port bus network enable OFF, ON
EDP.INPUT#p Port serial input function CMD, NONE, KEYBD, SCALE
EDP.STREAM#p Port streaming OFF, LFT, INDUST
EDP.SOURCE#p Port source scale for output scale_number
EDP.OFMT#p Port output stream select DEFAULT, CUSTOM
EDP.SFMT#p Port custom stream format 0-50 characters
STR.POS#p Custom stream identifiers Specify replacement text for token
Example: STR.PRI#1=L
See Section 10.5 on page 91 for information more about custom
stream formatting.
STR.NEG#p
STR.PRI#p
STR.SEC#p
STR.TER#p
STR.GROSS#p
STR.NET#p
STR.TARE#p
STR.POS#p
STR.NEG#p
STR.MOTION#p
STR.RANGE#p
STR.OK#p
STR.INVALID#p
For commands including “#p”, p is the serial port number.
Table 9-4. SERIAL Port Serial Commands
Command Description Values
SD Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit date using
the year-month-day order specified for the DATEFMT parameter, using
only the last two digits of the year.
ST Set time hhmm (enter using 24-hour format)
DATEFMT Date format MMDDYYYY, DDMMYYYY, YYYYMMDD, YYYYDDMM
DATESEP Date separator SLASH, DASH, SEMI
TIMEFMT Time format 12HOUR, 24HOUR
TIMESEP Time separator COLON, COMMA
DECFMT Decimal format DOT, COMMA
DSPRATE Display rate 1–80, in100-ms intervals
Table 9-5. FEATURE Serial Commands