Rice Lake 920i Installation Manual V1.05 - Manual (Page 35)

Configuration 31
Level 3 Submenus Port 1–Port 4
BAUD 9600
19200
28800
38400
57600
115200
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the port.
NOTE: The maximum baud rate for ports on serial expansion cards (port number greater than
4) is 19200.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted or received by the port.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the port.
EOLDLY 0
0–255 End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
HANDSHK OFF
XONOFF
HRDWAR Specifies whether XON/XOFF flow control characters or hardware handshaking is used.
Hardware handshaking is available only on Port 2.
ADDRESS 0
0–25 Specifies the decimal indicator address for RS-485 connections. RS-232 communications is
disabled if an address other than zero is specified for this parameter. RS-485 addresses must
be in the range 01–255.
BUS OFF
ON Specifies whether the port sends the data stream to a network bus. Specify ON only when
using serially-connected bus options.
INPUT CMD
PROGIN
KEYBD
SCALE Specifies whether the port receives remote command input, programmable input, remote
keyboard input, or scale input.
KEYBD is available only on Port 2; SCALE is available only on Ports 3 and 4.
NOTE: The keyboard interface is not hot-pluggable. Power-off the 920i before plugging
the keyboard cable into the Port 2 connector
STREAM OFF
LFT
INDUST Specifies whether data is streamed from the port.
SOURCE source_scale If STREAM is set to a value other than OFF, SOURCE specifies the source scale for data
streamed from the port.
OFMT DEFAULT
CUSTOM Specifies whether streamed data uses the default or a custom stream format.
SFMT format Specifies the custom stream format used for the streamed data. See Section 10.5 on page 91
for information about custom stream formatting.
SERIAL Menu
Parameter Choices Description
Table 3-5. Serial Menu Parameters (Continued)