Rice Lake Datalogic PowerScan PD7100 Series Laser Scanner - Manual (Page 58)

RS-232 ONLY Interface
50 PowerScan ® PD7100 Corded
Stop Bits
The stop bit(s) at the end of each transmitted character marks the end of transmission
of one character and prepares the receiving device for the next character in the serial
data stream. The number of stop bits selected (one or two) depends on the number
the receiving terminal is programmed to accommodate. Set the number of stop bits
to match host device requirements.
ENTER/EXIT PROGRAMMING MODE
1 Stop Bit
2 Stop Bits
DEFAULT