Rice Lake Datamax-ONeil I-4212e Mark II - Manual - Manual (Page 20)

Chapter 2 - Printer Setup 14
3. Route the ribbon under the Ribbon Idler and then out the front of the printer approximately 12
inches as shown.
 Ribbon Roll
 Ribbon Supply Hub
 Ribbon Idler
4. Close the Printhead Assembly and rotate the Printhead Latch to the locked position. Route the
ribbon up and then around to the Ribbon Take-Up Hub, winding it several times in a clockwise
direction to secure it in place.
 Printhead Assembly
 Printhead Latch
 Ribbon Take-up Hub
5. Close the cover and press the Feed button several times to position the ribbon and ensure proper
tracking.