Rice Lake Datamax-ONeil I-4212e Mark II - Manual - Manual (Page 23)

Chapter 2 - Printer Setup 17
4. Load media as described in section 2.2. Feed approximately 20 inches (50 cm) of media out
of the printer. Route the media over the Arc Plate and then back into the printer and around
the Rewinder Hub.
 Arc Plate
 Rewinder Hub
5. Wrap the media around the Rewinder Hub. Insert the end of the media into a Slot in the
Rewinder Hub. Slide the Media Retainer into the Slot to secure the media.
 Media
 Rewinder Hub
 Media Retainer
 Slot
6. Rotate the Rewinder Hub by hand to take up any slack in the media. There should be at least
2 or 3 full wraps of the media on the Rewinder Hub before starting printing to ensure tight
rewinded rolls.