Rice Lake MSI9300 PortaWeigh Crane Scale Operator Manual - Manual (Page 15)

MSI-9300 Crane Scale™ • User Guide Page 15
MEASUREMENT SYSTEMS INTERNATIONAL
Rev 1 7/27/02 for SW Ver 1-1
TOTAL
The MSI-9300 CellScale feature set provides Total and Statistics capabilities. The MSI-9300 keypad allows the
enabling and display of some of these features. More extensive total and statistics capability is provided when
a 9750A or 3750CS meter is part of the network. However, the MSI-9300 allows the setting of the following
Total features:
1) OFF – Total feature turned off
2) Autoload – The autoload feature provides an algorithm for totaling that requires a 3750CS equipped with
an auxiliary push button. Intended for commodity loading into containers. See the CellScale User Guide
for a complete description of the Autoload feature.
3) Autonorm – The Autonorm Total will automatically total all steady weights above the auto total threshold.
Once totaled, the weight must return to near zero before the scale will autototal again. The autonorm
total totals the last settled weight before the scale went back to zero, so be sure the weight is removed
rapidly from the scale.
4) Autopeak – Similar to Autonorm except the weight totaled will be the highest settled weight before the
weight returns to near zero.
5) Press – Indicates that a manual total key must be pressed to cause a total to occur. This can be the USER
key programmed to total, or total keys found on the 3750CS or 9750A indicators.
To Set the Total Mode
1
Func
2
TEST
a-Off
2
TEST
Unit
2
TEST
totaL
3
T
TARE
OFF
4
TEST
autoLd
4
TEST
autoNr
5
T
TARE
° Auto
6
0
ZERO
to exit
6
TEST
to select other Main
Setup Menu items.
1) Start the Setup Mode using the procedure on page 12.
2) Use the TEST (Scroll) key to scroll to “Total”.
3) With the display reading “Total” press the TARE (Select)
key. The currently programmed Total setting will display
flashing.
4) Use the TEST (Scroll) key to scroll through the total
modes.
In this example the mode will be changed to “AutoNorm” (AutoNr).
5) When the desired choice is shown, Press TARE (Select)
to select it.
Pushing TARE (Select) sets the Total mode, and exits back to the Main
Setup Menu.
6) The next Main Menu item, “° Auto” will appear. Either
select another Setup procedure with the TEST (Select)
key, or return to weighing mode by pushing ZERO
(Exit).