Rice Lake MSI9300 PortaWeigh Crane Scale Operator Manual - Manual (Page 7)

MSI-9300 Crane Scale™ • User Guide Page 7
MEASUREMENT SYSTEMS INTERNATIONAL
Rev 1 7/27/02 for SW Ver 1-1
MSI-9300 PORTA-WEIGH PLUS DISPLAY
The MSI-9300 has six 1.2” (30.5mm) ultrabright LED Digits along with annunciators. The brightness of the
display is automatically adjusted to the lighting conditions. When the ambient light is dim, the LEDs are lower
in intensity. When ambient light is bright, the LED intensity level is increased to allow sunlight readability.
Ttl 0
MOTION
RF
2
BAT
LOW
Net Grs kg lb
Tare
8.8.8.8.8.8
1
2
3
6 Digit Weight and Data Display
Center of Zero
Indicator
Set Points
1-3
RF Comm
Indicator
Weight in
Motion
Displaying
Tare Wt
Displaying
Total Wt
Displaying
Net Wt
Displaying
Gross Wt
Wt Unit is
kilograms
Wt Unit is
pounds
Light
Sensor
Low Battery
Warning
Minus Sign
Only used when
six digits are displayed
Middle segment used
for ≤5 displayed digits
KEYBOARD OPERATIONS
T 0
ZERO NET/GROSS TARE POWER TEST
1 2 3 4 5
1) POWER – Push to turn the scale on or off.
2) ZERO – Used to zero the scale. The zero range is usually 100% of full scale unless prohibited by legal-for
trade settings.
3) NET/GROSS – Switches scale between NET and GROSS weight readings (assuming a Tare value has
been stored).
4) TARE – When in GROSS mode, pushing TARE will zero any weight on the scale and cause the scale to go
into the NET mode. When in NET mode, pushing TARE will display the TARE value for 2 seconds, then
revert back to the NET weight display. In NET mode, pushing TARE twice will set a new Tare. Pushing
TARE followed immediately by ZERO will clear the Tare value and revert the scale to Gross Mode
5) TEST/USER Key – When pushed, this causes a display segment check, and provides battery and RF
Network information. Also programmable for USER desired functions. See SETUP USER KEY. User Key
Functions Available: Units (kg/lb) • Total • Scan List Increment (multi-channel systems) • °F/°C • Change
Network (SW V3-33 and above) • Test (default)