Rice Lake MSI9300 PortaWeigh Crane Scale Operator Manual - Manual (Page 19)

MSI-9300 Crane Scale™ • User Guide Page 19
MEASUREMENT SYSTEMS INTERNATIONAL
Rev 1 7/27/02 for SW Ver 1-1
CONTENTION CONSIDERATIONS
It is important to understand that only one transmitter at a time can be activated within a reception area. While
the transmitted signal consists of encoded digital data, only one carrier of any frequency can occupy airspace
without contention at any given time.
RF REMOTE CONTROL FCC STATEMENT
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment
and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected. Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equip-
ment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio
and TV reception. The user is cautioned that changes and modifications made to the equipment without the
approval of manufacturer could void the user’s authority to operate this equipment
BATTERY REPLACEMENT
The remote unit utilizes a CR-2032 Button Lithium Cell. In normal use it will provide
1-2 years of operation. Access for replacement is accomplished by removing the battery
access cover by pressing down firmly on the label area and sliding it off. Once the unit is
open, remove the battery by sliding it from beneath the holder. Replace the cell with the
same type while observing the polarity shown.