Rice Lake MSI9300 PortaWeigh Crane Scale Operator Manual - Manual (Page 17)

MSI-9300 Crane Scale™ • User Guide Page 17
MEASUREMENT SYSTEMS INTERNATIONAL
Rev 1 7/27/02 for SW Ver 1-1
To Change Current RF Network
This feature is intended for use in large installations where, for service or work load purposes, the crane scale
must be used on a new network. When the crane scale is a remote (slave) device, the Master CellScale must be
configured with a matching channel 5 scanlist to allow seamless Network migration. In other words, the “MY
ID” must be identical to the unit it is replacing. Make sure two remote devices with the same “My ID” are
never on at the same time in the same Network.
When the crane scale is a Host (Master) device, only the network number can be changed, the master “My ID”
will not change. All remote devices on the previous network will lose communciation.
4
T
TARE
000000
5
111111
5
222222
0
ZERO
to cancel and exit
(Select) to select it.
Pushing TARE (Select) reconfigures the Modem to new network settings.
5) The display will go into test mode while the network set-
tings are being altered. When the modem is successfully
changed, the display will return to the weight mode.