Rice Lake Datamax M-Class Mark II - Manual (Page 12)

6 Chapter 2 - Printer Setup
5. Close the Printhead Assembly and press down until it locks into place.
6. Close the cover and press the
FEED
button several times to position the media and ensure
proper tracking.
n Printhead Assembly
If the printer does not correctly sense the top of each label, it may be necessary to calibrate the
printer. See section 3.5 Media Calibration.
;
The printer is factory set to use 4-inch media (and ribbon, if thermal transfer equipped). When using
a different width of media/ribbon, please refer to section 5.3.