Rice Lake Datamax M-Class Mark II - Manual (Page 48)

42 Chapter 4 – Menu System
SPEED
COMMANDS
Determines the way DPL Print, Feed, Slew, and Reverse commands are handled,
where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores DPL speed commands; instead, the speeds are controlled via the menu
setting.
TOF SENSING
COMMANDS
Determines the way in which DPL Gap, Continuous, and Reflective commands are
handled, where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores DPL TOF commands; instead, TOF is controlled via the menu setting.
SYMBOL SET
COMMAND
Determines the way in which DPL Single and Double Symbol Set commands are
handled, where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores DPL Symbol Set commands; instead, the Symbol Set selection is controlled
via the menu setting.
CNTRL-CODES
(DATA) Determines the way in which DPL SOH, STX, CR, ESC, and ^ codes are handled,
where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores DPL Control Codes; instead, the control code functions are established via
the menu setting.
STX-V SW
SETTINGS
Determines the way in which the DPL <STX>V command is handled, where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores the option-enable command; instead, the option selections are controlled
via menu settings.
MAX LENGTH
COMMAND
Determines the way in which the DPL <STX>M command is handled, where:
ENABLED Processes commands normally. (Default Setting)
DISABLED Ignores the maximum label length command; instead, Maximum Label Length is
controlled via the menu setting.
OPTION
FEEDBACK
Allows feedback characters from an optional device to be returned to the host
device, in the format of: <A;B;C;D;E;F>[CR]
Where:
A
-
Is the device type: R = RFID; and, S = Linear Scanner
B
- Is the resulting status: C = entire label complete; F = faulted (failed)
label; and, U = unknown
C
- Is the number of expected reads for bar codes or tags, given in two
characters.
D
-
Is the number of good reads for bar codes or tags, given in two characters.
E
- Is the printer’s internal Job and Sub Job Identifier, given in four characters
each.
F
-
Is the data that was read, delimited with semicolons (;) on multiple reads.
DISABLED No data is reported. (Default Setting)
SCANNER Linear Scanner information is reported.
RFID HEX RFID information is reported in hexadecimal format.
RFID ASCII RFID information is reported in an ASCII format.
PROCESS SOH
(DATA)
Determines the way the printer responds to an Immediate Command (e.g., Get
Status, Module Storage, etc.), where:
ENABLED Operations are interrupted upon receipt to process the command.
DISABLED Processes commands normally. (Default Setting)