Rice Lake Datamax M-Class - Manual (Page 65)

M-Class 57
Communications (continued)
NIC ADAPTER ♦
Network Interface Card Adapter (optional). If not present, this displays ‘NOT
INSTALLED’ when accessed. After making changes to these parameters, save the
changes, exit the menu system, the printer will then reset for the changes to take
effect.
IP ADDRESS The static IP address of the NIC Adapter. This is in standard dotted-decimal format.
SUBNET MASK The static subnet assigned to the NIC Adapter.
GATEWAY Specifies the network gateway address the NIC Adapter should use.
SNMPTRAP DESTINATION Selects the Network IP address where all SNMP Traps will be sent. If zeroed, no
traps are sent. The Receiver must have SNMP service installed.
IP DISCOVERY This is the address discovery method used by the NIC Adapter if a static address is
not utilized. If no server for any of the discovery methods is found, the static value
specified is used.
Note: For faster NIC Adapter boot times, disable any discovery methods not used.
ENABLED Default. Modifications to IP, Subnet Mask, or Gateway addresses will not be allowed.
WARNING! An IP Address assigned by a server has precedence over any static IP Address stored in the NIC Adapter.
DISABLED
Disables IP Discovery.
Note: Select this option to ensure that any stored static IP is used by the NIC Adapter.
SET FACTORY DEFAULTS Resets all of the network parameters to factory default settings. Including some
parameters that are not accessible through the printer’s menu.
HOST SETTINGS
♦
Settings which affect all communications with a host.
HOST TIMEOUT
10 SEC (1-60)
The number of seconds a communications port must be idle before the printer may
process data from a different port. This value is also used to “timeout” an image /
label format download (i.e., if, at any time, data flow stops before a complete label
format is received, the data will be ignored).
CONTROL CODES Allows the operator to change the prefix of the software commands interpreted by the
printer.
STANDARD CODES Hex 01 = SOH command; Hex 02 = STX command; count-by = ^; Hex 1B = ESC; Hex 0x0D =
Carriage Return
ALTERNATE CODES Hex 5E = SOH command; Hex 7E = STX command; count-by = @; Hex 1B = ESC; Hex 0x0D =
Carriage Return
ALTERNATE CODES 2 Hex 5E = SOH command; Hex 7E = STX command; count-by = @; Hex 1B = ESC; Hex 0x7C =
Carriage Return
CUSTOM CODES Each DPL command (SOH, STX, CR, and count-by) may be selected by entering the
desired Hex code. (The and Keys will scroll the characters, while the ENTER Key
selects character and then advances the cursor.)
N
o
t av
ai
labl
e w
hen “
IP
D
is
c
o
v
e
ry
” i
s
enabl
ed