Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 11)

Mounting Plate Installation and Setup 7
2.4.2 Serial Wiring
Serial communications are connected to the CPU board using removable screw terminal plugs on J6, J8 and J9 (see
Figure 2-8).
To connect the communications cable to the remote display, do the following:
1. If the enclosure is not open, disconnect power and open the remote display by removing the captive screws
on the bottom of the enclosure and lower the mounting plate.
2. Open the captive retaining screws (Figure 2-6) and flip forward the hinged mounting plate.
Figure 2-6. LED Primary and Secondary Display Boards (7-Segment Display)
3. Loosen the serial cable cord grip and push enough communications cable into the enclosure to allow
attachment to the CPU board.
4. Strip 1/4" (.65 cm) of insulation from the serial cable ends.
5. Make cable connections for RS-232, RS-485, or 20 mA current loop communications as described in
Table 2-2.
6. Remove any excess cable from inside the enclosure. Tighten the serial cable cord grip.
If you are experiencing RF Interference, follow the instructions below.
1. Loop the serial wires through the cylindrical ferrite (PN 66730) provided with this manual. See Figure 2-7
below.
2. Using the plastic cable ties provided, secure the wires to the ferrite and the serial cable to the learn switch
wires to keep ferrite from contacting the CPU board. See Figure 2-7 below.
Figure 2-7. Cylindrical Ferrite Placement
Captive retaining
screw
Note
Cylindrical
ferrite
Plastic cable ties