Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 17)

Configuration 13
CONFIG Menu
7-Segment Display
Parameter
8-Character Matrix
Display
12-Character
matrix Display Choices Description
Level 2 Submenus
TIMDAT TIMEDATE TIME/DATE Enabled
Format
Set
Date To enable time and date
Displays USA or ISO time format
Sets hours/minutes and month/day/year
Can disable date
TEMP TEMP TEMPERATURE F
C Select Fahrenheit or Celsius
TEMPADJ TEMPADJ DEGREE ADJUST + 5%
- 5% +/- 5 degrees display. Can add or subtract up to +/- 5
degrees of both Fahrenheit or Celsius
BRIGHT BRIGHT BRIGHTNESS Day
Night Selects the brightness during day or nightime hours
SUPP O SUPP O SUPPRESS 0 On
Off Select On to enable the suppression of leading zeros
in a weight.
MIRROR MIRROR MIRROR On
Off Select On to display LED readout in reverse. The
menu is viewed normally.
STDSTL STD STL STAND STILL On
Off Select On to enable display updated weight only when
the scale is not in motion.
ADDRES ADDRESS ADDRESS 0 through
31 Assign a command address by selecting a number
between 0-31.
MSG TM MSG TIME MESSAGE TIME 5, 15, 30
sec., 1, 5
minutes Select amount of time a message stays on the remote
display. Time can vary from 5 seconds to 5 minutes. If
no serial command is used, then this parameter is not
used. (7-segment DM command only)
D TEST DSP TEST DISPLAY TEST On
Off Set this parameter On to enable a countdown display
test on start up.
RESET RESET RESET CONFIG Resets the remote display to default parameters
LEARN EN LEARN EN LEARN EN On
Off Enable allows weight learn operation. With Learn off,
the unit operates for demand messages.
Table 3-2. Configuration Menu Summary - Level 2
Parameter Choices Description
Level 3 submenus (TIMDAT Parameter)
ENABLE On
Off Select On to enable time and date option. Note: You need an additional chip called a
“snap hat.” It is recommended that you disable the time/date feature if you don’t
want this addtional chip. Will display at zero or less weight only.
FORMAT USA
ISO Displays in either USA or ISO (military time) format
SET HH/MM
MM/DD/YYYY Sets hour/minutes and month/day/year
DATE On
Off Select Off to disable the date display if the date and time option is installed. Time is
still displayed.
Brightness (BRIGHT Parameter)
DAY 1-10 Selects the brightness during day. Brightness is set from 1-10 or 10 to 100% of the
full brightness. IntelliBright averages measured ambient light over a ten minute time
span.
NIGHT 1-5-10 Selects the brightness during night. Brightness is set from 1-10 or 10 to 100% of the
full brightness. IntelliBright averages measured ambient light over a ten minute time
span.
Table 3-3. Configuration Menu Summary - Level 3