Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 9)

Mounting Plate Installation and Setup 5
Figure 2-2. Tab Pin Assembly on Inside of Remote Display Enclosure
2.3 Wall Mounting
The LaserLight remote display can be mounted to any vertical surface
or pole.
Select a site and use installation screws or wall anchors to secure the
remote display to a wall using the mounting holes on the flange tabs.
The flange hole size accommodates 1/4" hardware. If installing the
remote display on a pole, an optional pole mounting kit is required, this
kit fits 4" - 8" poles (see Section 4.4). Once the enclosure is secured,
slide the mounting plate down so that it is hanging freely from the
enclosure with the tabs secured against the pins. This enables the user to
continue wiring the remote display.
2.4 Wiring
The LaserLight remote display provides three cord grips located on the underside of the enclosure for cabling; one
for the power cord (supplied), and two for serial communications. The LaserLight remote display is pre-wired.
Ribbon cables connect the CPU board to the digit display boards. An A/C power cord is also supplied. Only the
serial communications cable must be connected. Use the following steps to wire the remote display.
The LaserLight remote display has no on/off switch. Before opening the unit, ensure the power cord is
disconnected from the power outlet.
1. If the remote display is not open, remove the captive screws located on the bottom of the remote display
enclosure.
2. Lower the mounting plate from the inside of the enclosure.
Use caution when lowering or raising the mounting plate to ensure the LEDs do not touch the enclosure
sides.
3. Loosen the retaining screws located on the front of mounting plate (Figure 2-4). The mounting plate is
hinged on a backplate frame to allow easier access to the AC wiring and the CPU board.
Figure 2-4. Retaining Screw Location
Figure 2-3. Mounting Flange
4 Inch LED Remote Display Shown
Flange tab with
holes to
accommodate
1/4
" hardware for
mounting
WARNING
Important
Retaining screw