Canon FAX-L800 - Manual (Page 228)

Canon FAX-L800 User’s Guide ENGLISH
12-10 Chapter 12 Other Special Features
How the Fax Operates with Default Settings
There are many minor features that you can change to customize the operation
of the fax. Some of these features are listed in the table below. The description in
the third column is the default setting. In other words, this is how the fax will
operate unless you change the referenced setting.
If your fax is not operating as described, this means the default may have already
been changed. In such a case you may want to go to the referenced page to
restore the default setting.
Feature Menu Item Description of default
Batch sending BATCH TX If several documents for the same destination with the same
telephone number are stored in the memory for delayed
sending, when the timer goes off for one of the documents all
other documents for the same destination are sent together in
the same transmission, regardless of their time setting. (
Q16-10)
Button press sound VOLUME CONTROL
KEYPAD VOLUME Every time you press a button on the numeric keypad you will
hear a beep. The volume of this beep can be adjusted or it can
be turned off. (
Q16-6)
Date format DATE SETUP In the standby mode, the date is listed in the format
DD/MM ’YY. Two other formats are available. (
Q16-25)
Dialling timeout TIME OUT The fax automatically pauses five seconds after you press a
speed dialling button to allow you to dial other numbers for
sequential broadcasting. You can turn the timeout feature off.
(
Q16-11)
Document smaller
than paper SELECT CASSETTE
CASSETTE SW B If you receive a letter-size document and only a larger paper size
is available, the fax prints the document on the larger paper. If
you do not want the smaller documents printed on larger paper,
you can receive them in the memory. This switch is effective
only when the letter size paper runs out. (
Q16-15)
Document too large
for paper SELECT CASSETTE
CASSETTE SW A If you receive a legal-size document and only letter-size paper is
available, the document will be divided over two pages or
reduced. If you do not want to divide documents, you can
receive them in the memory. This switch is effective only when
the side cassette is set to legal size and out of legal size paper.
(
Q16-15)
ECM sending/receiving ECM TX
ECM RX
The fax is set to conduct all transactions using ECM (error
correction mode). If transmission speed appears to be extremely
slow, you may be able to speed up transmission time by turning
ECM off. (
Q16-9, 16-13)
Energy Saver ENERGY SAVER The Energy Saver feature is off and will remain off until you
turn it on. (
Q3-19, 16-26)
Language DISPLAY LANGUAGE The initial display language is English. Other languages are
available. (
Q16-26)