Canon FAX-L800 - Manual (Page 326)

Canon FAX-L800 User’s Guide ENGLISH
16-18 Chapter 16 Summary of Important Settings
3.DELETE FILE Delete a mailbox.
SET BOX # Enter the number of the mailbox you want to delete.
PASSWORD Enter the password protecting the mailbox you want to delete.
2.RELAY TX GROUP Set up relay box so your fax machine can relay document
transmissions to other fax machines in your area. (
Q9-3)
1.SETUP FILE Set up the relay box.
SET RLY TX GROUP# Set a two-digit relay group number (00-99).
1.GROUP DIAL NAME Give the relay group a name (length: 24 characters).
2.PASSWORD Assign a four-digit password to protect the relay box settings.
3.SUBADDRESS Enter a 20-digit (max.) ITU-T subaddress.
4.RX PASSWORD Enter a 20-digit (max.) ITU-T password.
5.SELECT ORIG UNIT Set your fax to check the incoming relay command to make sure the originator
is registered.
ON
TEL=
Receives and obeys incoming relay commands for registered originators only.
Use the One-touch or Coded Speed Dialling buttons to register originators.
OFF Receives and obeys all incoming relay commands.
6.PRINT RX DOC. Turns printing on/off for documents received for relay.
ON Prints a copy of every document relayed.
OFF No copy is printed.
7.SELECT LOCATION
TEL=
Use the One-touch or Coded Speed Dialling buttons to select the fax numbers
to receive the document relayed from your fax machine.
8.TX REPORT Send a TX report from your fax machine (the relay unit) to the originator of
the transmission.
TRANSMIT Transmits a document relay report to the originator.
NOT TRANSMIT No report is transmitted.
9.TX START TIME Set the fax machine to hold the document from the originator and then relay it
at a specified time. Use 24-hour setting. Up to 5 time settings are possible.
10.RELAY B’CAST
OFF Turn relay broadcasting off temporarily without cancelling or changing all of
the relay box settings.
ON In order for relay broadcasting to occur, this setting must be on.
2.CHANGE DATA Change or add the settings on the relay box.
SET RLY GROUP TX# Enter the number of the relay box you want to change.
PASSWORD Enter the password protecting the relay box settings.
You can now change any of the settings listed in the table above
(1. SETUP FILE).
3.DELETE FILE Delete a relay box and all settings.
SET RLY TX GROUP# Enter the number of the relay box you want to delete.
PASSWORD Enter the password of the relay box you want to delete.