Torbal AGC Series Manual - Manual (Page 29)

Instruction Manual - TORBAL AGC Series
2. Commands Co On and Co OFF will be displayed sequentially. To enable parts counting and
proceed with configuration press the “T” (YES) key when Co On is displayed. If the function
is already enabled and you wish to disable it, press the “T” (Yes) key when Co OFF is
displayed.
3. After enabling parts counting, select the sample size you want to be used for establishing the
average piece weight (APW). SPL – 10 will be displayed indicating that the default sample
size setting is 10 pieces. To accept the sample size press the “T” (YES) key. To change the
sample size press the 0 (NO) key.
To Accept To Change
The sample size selection can range from 1 to 100 pieces. By applying short single presses to the
0 (NO) key the sample size will change in increments of one. By holding the 0 (NO) key
pressed, the sample size will change in increments of 5. To select a sample size of 99, press and hold the
0 key until the display reads 95, and apply four single presses until the sample size reads 99. Once a
desired sample size is displayed, press the “T” (YES) key to accept and confirm the selection.
29