Torbal AGC Series Manual - Manual (Page 61)

Instruction Manual - TORBAL AGC Series
4. To enter a weight, use the following keys: the 0(NO) key to increment a digit; “T” (YES) to
accept and go to the next digit; “P” to insert a decimal; “Function” to accept the entire setting; and
“C” to clear and start over . To become familiar with setting the weigh limits, see Table 8.C.4.
Table 8.C.4, Example: Setting a weight limit of 20.123g
Current Display Action to take Key to use Number of depressions Display becomes
- Increment the digit 0(NO) 3 2
2 Accept and go to next digit T(YES) 1 20
20 Insert a decimal P 1 20.0
20.0 Increment the digit 0(NO) 1 20.1
20.1 Accept and go to next digit T(YES) 1 20.10
20.10 Increment the digit 0(NO) 2 20.12
20.12 Accept and go to next digit T(YES) 1 20.120
20.120 Increment the digit 0(NO) 3 20.123
20.123 Accept the entire setting Function 1 --
5. After setting the UNDER limit the current OVER limit setting will be displayed. Command OVER
and the over-limit weight setting are displayed sequentially. If this is the first time the function is
used the setting will be 0.000g. Any new setting will be saved until changed or cleared through the
master RESET.
6. If an OVER limit is already set and no change is necessary, press “T” (YES) to accept and continue.
If you wish to change the setting press 0(NO).
To accept To change
61