Torbal AGC Series Manual - Manual (Page 60)

Instruction Manual - TORBAL AGC Series
(C) Check Weighing
The check weighing function is used to compare a weight of an object against a preset target
range. To set the limits and use the check weighing function follow the steps below.
1. Upon entering the check weighing function, the UNDER limit is displayed. Command UNDER and
the under-limit weight setting are displayed sequentially. If this is the first time the function is used,
the setting will be 0.000g. Any new setting will be saved until changed or cleared through the
master RESET.
2. If an under limit has already been set and no change is necessary, press “T” (YES) to accept and
continue. If you wish to change the setting, press the 0(NO) key.
To accept To change
3. After pressing the 0 (NO) key a dash will appear on the display. A weight limit may then be
entered.
60