Torbal DRX300 Manual - Manual (Page 41)

Instruction Manual - TORBAL DRX 5 Series
CHAPTER 16.
USING THE FILLING METER
If the Remaining to Fill feature is enabled, the remaining to fill weight will be displayed in the upper left corner of the
display.
The filling meter will assist you in the filling process. The filling meter helps to stop filling at the desired target weight
which was entered as the remaining to fill weight.
1. Locate the arrow at the right end of the filling meter. The arrow represents the desired filling weight that had been
programmed as the remaining to fill weight.
2. When an ingredient is added, the filling meter begins to move towards the arrow. The meter reaches the arrow
when the desired weight has been placed on the pan.
3. The filling meter is non- linear. As the weight is placed on the pan, the meter begins to move slowly and becomes
more sensitive as it approaches the desired weight. The resolution of the meter becomes greater as more weight is
placed on the pan. This allows a more precise and accurate weight. Slow down the addition of weight into the pan
when the meter is approximately three quarters full, since at that point you have added approximately 90% of the
desired weight.
41