Garmin 210 - Manual (Page 62)

m AyXIUlïMEl
■ 11 Inlajaa' Opliom Seiiip
I
hikifm’ t onnais
Interface Setup
Input/Output Port 1
I/O Format
Transfer Mode
Ready for command
Output Port 2
Output Format
Data Transfer
^ Data Transfer
Ho In/NMEA Out
Ho In/Ho Out
RTCM In/HMER Out
RTCH In/Ho Out
Hu'uui'..... .......
j Use cursor to hiahBÿit choice, EHT to accept
Input/Output Port 1
I/O Format
Transfer Mode
Ready for command
Output Port 2
Output Format
' Save Modo
j Request Almanac
( Request Proximity
' Request Routes
Request Track
Request Maypants
Send Almanac
I, Send Proximity
Send Routes
Send Track
1 Send Haypokits
I Use cursor to highlight choice, EHT to accept
c
The GPSMAP interface setup submenu lets you control two ports for con­
necting external NMEA electronic devices and a PC/printer (MAP 205 units
provide only data transfer and NMEA 0183 interfaces). The first port, listed at
the top of the interface setup window, is an Input/Output port that lets you
specify one of five interface formats:
Data Transfer is a proprietary interface that allows you to exchange data
such as waypoints, routes and track logs between GPSMAP units.
No In/NMEA Out provides navigation information to a compatible NMEA
device such as an autopilot or radar. The GPSMAP provides NMEA 0180,
0182,0183 v.1.5 and 0183 v.2.0 output options. See Appendix B for addi­
tional NMEA sentence information.
No In/No Out turns off both interface ports.
RTCM In/NMEA Out provides an input interface for connection of a DGPS
beacon receiver and a selectable NMEA output.
RTCM In/No Out provides an input interface for connection of a DGPS
beacon receiver, but provides no output capabilities.
To specify an I/O format, highlight the I/O format field, press (Sd and select
an option from the submenu listing. Once you’ve selected an I/O format, you
may need to specify other preferences in various fields below the format field
for transfer modes, NMEA formats, receiver frequency, etc.
When Data Transfer is selected, you’ll need to specify what information to
request or send to the remote unit through the Transfer Mode field. The ‘slave’
setting lets you control all data transfer from the connected GPSMAP, while the
other settings request or send specific data from the main GPSMAP unit.
52