Garmin 210 - Manual (Page 80)

70
Received Invalid Waypoint —A waypoint was received during upload transfer that
has an invalid identifier.
Receiver Failed —A failure in receiver hardware has been detected. If this message
persists, do not use the unit and take it to an authorized dealer for repair.
Route is Full —You have attempted to add more than 50 waypoints to a route.
Route Waypoint Deleted —route waypoint entered does not exist in the database
and has been deleted from the route.
RTCM Input Failed —DGPS data being received has been lost. You are no longer
receiving the beacon signal.
Searching the Sky —The GPSMAP is in searching the sky for almanac data or the unit
is in AutoLocateT*^ mode.
Stored Data Lost —All waypoints, routes and almanac data has been lost due to
internal battery failure.
Tinier Expired —The countdown timer has expired.
Track Memory Full —The track memory is full and no additional track plot will be
recorded until the track memory has been cleared or set to wrap mode (see page 57).
Transfer Completed —The receiver is finished uploading or downloading informa­
tion to the connected device.
User Card Operation Complete —The user card data transfer has been completed.
Waypoint Exists —The waypoint name you’re entering already exists in memory.
Waypoint Memory Full —^You have used all 500 waypoints in the GPSMAP system.