Garmin 210 - Manual (Page 63)

whenever an NMEA output is selected for the GPSMAP system, you’ll need
to select an option from the NMEA Eormat field. To choose an NMEA format,
highlight the NMEA Format field and press Once you’ve selected a for­
mat, the GPSMAP will automatically set the proper baud rate for the NMEA
format you’ve selected.
If the I/O Format is set to accept RTCM input for connecting a differential-
ready GPS receiver beacon, you will need to specify a frequency in the Beacon
Receiver Tuning field and select a bit rate from the Beacon Receiver Bit Rate
options. The default frequency will be 304.0kHz or the last DGPS frequency
tuned. The DGPS status will be displayed on the status page, with the frequen­
cy, signal-to-noise ratio, distance to transmitter and status shown.
The GPSMAP’s second port is an output only port for connecting an RS-232
serial printer. Once as printer has been connected, you can print speed and
course over ground data. This information can then be used to review your
speed and course over extended cruises or for dead reckoning navigation. To
connect to a PC printer, you’ll need to attach a 9-pin ‘D’ connector to the
ground and RS-232 leads of the GPSMAP wiring harness (see Appendix B).
To output to a PC printer:
1. Highlight the Output Format field and press the® key.
2. Use the# key to select the 'printer out' option and press ®
3. Highlight the Baud Rate field and press the® key.
4. Use the # keypad to select a baud rate and press the ® key.
5. If you prefer to enter a different output interval for printing, highlight the Output
Interval field and press the ® key.
6. Enter the desired time interval and press the ® key.
iVME4 Setup
P i iuta Inta'faee Setup
Interface Setup
Input/Output Port 1
I/O Format
ИМЕЙ Format
Baud Rato
Output Port 2
Output Format
Ho ХП/НМЕЙ Out
ИМЕЙ 0180
ННЕЙ 0180
НИЕЙ 0182
ННЕЙ 0183 VI.5
ИМЕЙ 0183 V2.0
Huuut
Use curtor to highlight choice, EHI to occept ~~]|
~||| Conoei~| JL □L JL
Interface Setup
Input/Output Port 1
I/O Format RTCM In/НМЕЙ Out
HHEA Format НМЕЙ 0183 V2.0
Baud Rate 1200
Beacon Revr Tune To ______ kHz
Beacon Revr Bit Rote 25 bps
Output Port 2
Output Format Ho Out
I
Press EHT to see list of options
c 21
Jl tl i
53