Garmin 210 - Manual (Page 70)

SECTION
11
C-BCITRIDCES
Insaling & Removing
Ciiiliiiiges
The GARMIN GPSMAP system uses G-chart™ digital cartography to display
nautical charts on-screen. G-chart™ cartridges are installed in the card slot
located at the bottom right of the GPSMAP unit. G-chart™ cartridges may
be installed or removed at any time, whether the unit is on or off.
To install a G-chart™ cartridge:
1. Turn the latch ring 1/4 turn counterclockwise and open the cartridge door.
2. Insert the card (label facing front and G-chart™ logo at top) into the slot.
3. Use your thumb to firmly push the cartridge into place, until the cartridge will
not go any further into the unit If your GPSMAP is on, a confirmation tone will
sound when the cartridge has been properly installed and accepted.
4. Close the cover and turn the latch ring 1/4 turn clockwise to secure. The car­
tridge cover features a sealing gasket to keep the G-chart™ area waterproof.
A'
If you insert a G-charf* cartridge and get a 'card format not recognized' message,
try removing the card and reinserting it If the card is still not recognized, contact the
dealer you purchased it from for assistance. G-charf* cartridges are not water­
proof, and should not be exposed to moisture or excessive static charges.
60
To remove a G-chart™ cartridge:
1. Turn the latch ring 1/4 turn counterclockwise and open the cartridge door.
2. Grasp the card atthe bottom groove and pull firmly to remove.
3. If your GPSMAP is on, a confirmation tone will sound when the G-chart™
cartridge has been removed.