Scsi configuration jumpers, Figure 4 scsi configuration jumper block, Table 13: default jumper settings – Ciprico Rimfire 3880 User Manual
Page 48
Advertising
21020285 D
User’s Guide
Chapter 3 Hardware Installation
Page 3 - 6
Step 2: Jumpers and Termination
SCSI
Configuration
Jumpers
This block of jumpers is used to select power-up defaults for:
•
Adapter SCSI ID
•
SCSI Bus reset on power-up and system reset
•
SCSI Bus Parity
The SCSI Configuration jumper block is illustrated below:
Figure 4 SCSI Configuration Jumper Block
The default settings of the jumper block are shown in the above figure and the
table below.
Pins
Description
Default
1-2
Reserved
OUT
3-4
OUT
5-6
Enable SCSI Parity Checking
OUT = Selected
7-8
SCSI bus Reset at Power-up
OUT = Selected
9-10
SCSI ID Bit 3
Table 13: Default Jumper Settings
Advertising