Step 4: apply power and observe leds, Meaning of led’s, Figure 13 location of leds – Ciprico Rimfire 3880 User Manual
Page 54: Power-up sequence, Both leds will briefly light, then the green wi, The amber led will stay lit for less than 5 sec, The amber led will go out, indicating self-test
21020285 D
User’s Guide
Chapter 3 Hardware Installation
Page 3 - 12
Step 4: Apply power and observe LEDs
Step 4: Apply
power and
observe LEDs
After you have inserted the board into the VMEbus slot, apply power to the
system.
There are two LEDs on the faceplate of the RF3880: one is green and the other
is amber.
Meaning of
LED’s
The LED’s are used in the following manner:
•
The green LED indicates BUSY status when the board is processing
commands.
•
The amber LED indicates an ERROR status.
Figure 13 Location of LEDs
Power-up
Sequence
At a normal power-up you should observe the following:
1.
Both LEDs will briefly light, then the green will go out.
2.
The amber LED will stay lit for less than 5 seconds, while self-test is
running.
3.
The amber LED will go out, indicating self-test has passed.