Sangean DDR-63+ (V1) - Manual (Page 12)


.
.
.
.
5.
Connecting your radio to your computer network
Configuration
Place your radio on a flat surface and plug the mains lead into the mains socket located on the
back of your radio ensuring that the plug is pushed fully into the socket.
If you wish to use a wired network connection, plug the Ethernet cable into the socket at the
back of the radio.
Plug the other end of the mains lead into the wall socket and switch on the wall socket.
IMPORTANT:
The mains plug is used as the means of connecting the radio to the mains supply. The mains
socket used for the radio must remain accessible during normal use. In order to disconnect the
radio from the mains completely, the mains plug should be removed from the mains socket
outlet completely.
When you apply power, the display on the radio will light up and say: ‘WELCOME’ and‘STARTING’
with a progress indicator. The first time that you use your radio (or after Factory Reset) the display
will show “Setup wizard” and “YES” will be highlighted on the screen. Press the Select button
to start the setup wizard. The screen will ask if you wish to run the setup wizard again at the
next start up. This will lead to the main menu.
Press the Tuning Up or Down buttons on the touch panel (Alternatively, the Folder Up or Down
buttons on the remote control handset) to highlight the desired clock format (either 12 Or 24 hour)
then press the Select button to enter your selection. A menu allowing you to specify the auto
update option for the clock will appear on the display. The default of ‘Update from Network’ will be
the best option for most users.