Sangean DDR-63+ (V1) - Manual (Page 88)

87
Press the Folder Up or Down buttons until the 'Volume:' option is highlighted on the display
and press the Select button if you wish to change it. The radio uses the saved volume setting
for each alarm when it sounds. Set the required volume using the Folder Up or Down buttons
and the Select button to confirm the setting.
In order to store the alarm settings press the Folder Up or Down buttons until 'Save' is highlighted.
Press the Select button to store the alarm settings. Your radio will show 'Alarm saved' and will
then go back to the list of alarms with the new alarm setting shown in the display. If you decide
not to save the settings, press the Back button. The display will show 'Save changes' with a
'YES' or 'NO' option. Press the Folder Up or Down buttons to choose 'NO' and then press the
Select button. 'Alarm not saved' will show on the display. Active alarms are shown using small
alarm indicators at the bottom of the playing displays and on the clock display when in standby.
9.
10.
Note:
If you make a mistake at any point while setting the alarms, use the Back button to go back to the
previous screen.
When the alarm sounds
The buzzer or radio alarm will sound at the selected times for up to 60 minutes unless cancelled.
The volume used for the alarm will be as specified during the alarm setting procedure. If the radio
cannot connect to the specified radio station, the buzzer alarm will be used instead. To cancel an
alarm, press the Standby button to return to standby mode. The alarm icon will fl ash at the bottom
of the playing mode displays, and the radio will automatically switch back to standby mode when the
60 minutes have elapsed.
Setting the alarm clock - cont.