Sangean DDR-63+ (V1) - Manual (Page 80)

79
Navigating your iPod
Use the Menu button on the remote control to navigate to higher level menus on your iPod.
Use the Folder Up or Down buttons on the remote control as required to move up and down
a menu screen on your iPod.
Press the Select button to choose the highlighted on screen menu item. If this item is a lower
level menu item, you may then navigate further using the Folder Up or Down and Select buttons.
Note:
iPod models vary in how they respond to the menu button. Not all iPods allow full menu navigation.
.
.
.
Playing a file on your iPod
When you have found the required item use the Select button to start the iPod playing (or the
Play / Pause button - but see note below).
Adjust the volume to the required setting using the Volume buttons on your radio.
To pause playback press the Play / Pause button. To resume playback press the Play / Pause
button again.
iPod's do not have a Stop button (they use the Pause function). To play an alternative selection,
use the iPod menus to make the selection using the Play / Pause button to stop playing the
current item if needed.
.
.
.
.
Note:
iPods vary in how they respond to the Play / Pause button dependent upon the iPod model and
software revision. Play / Pause may pause and resume the current selection, or it may pause
the current selection and then start playing a new selection. The use of the Select button to start
playing an item avoids this inconsistency.